Pearce Grip PG-G526 Plus Zero Extension (Glock 26 Gen4/5)

The Pearce PG-G526 fixes the single biggest ergonomic complaint about the Glock 26, the pinky tuck. Factory flush mags leave the shooter's little finger either curled under the baseplate or floating off the grip entirely, which kills recoil control on a gun that already sits heavy in the hand. The PG-G526 replaces the flush floorplate with a contoured polymer piece that adds roughly 5/8 inch of grip length, enough for a full three-finger hold, without adding a round or bulking the footprint enough to hurt concealment.

Install is tool-less. Depress the factory floorplate retainer, slide the flush plate off, transfer the spring and follower, and snap the PG-G526 into place. It locks against the magazine tube with the same retainer system the OEM plate uses. There is no capacity change because the internal spring, follower, and tube are unchanged, this is a grip extension only, not a capacity extension.

The PG-G526 is the Gen4/Gen5-specific version of Pearce's Glock 26 product line. The earlier PG-26 fits Gen3 mags only; the two are not interchangeable because the floorplate geometry changed between generations. Verify you are running Gen4 or Gen5 factory magazines before ordering.