HB Industries CZ Bren 2 Flat-Faced Trigger

The factory CZ Bren 2 trigger is mechanically sound but ergonomically stock. Pre-travel is long, the curved factory shoe slides the finger off-center under fast strings, and over-travel adds a full extra millimeter of motion after the break. The HB Industries Bren 2 trigger is a billet 6061-T6 replacement that swaps in with a single roll pin and addresses all three complaints without touching the factory hammer or sear geometry.

The flat face centers the finger pad through the long Bren 2 reach and gives a more repeatable break across rapid fire. HBI specs the pre-travel reduction at over 35 percent and "nearly eliminates" over-travel through a precision-machined fit between the trigger body and the lower receiver. Pull weight stays essentially factory because this is a shoe upgrade, not a spring kit.

Finishes match the rest of the HBI Bren 2 lineup at Black, Tungsten, Burnt Orange, and Red. Counts toward 922R compliance and ships with replacement roll pins. Drop-in install in under five minutes with a punch and a hammer.